Optimization of an ultrasonic-assisted biodiesel production process from one genotype of rapeseed (TERI (OE) R-983) as a novel feedstock using response surface methodology
- Authors: Almasi, Sara , Ghobadian, Barat , Najafi, Gholam , Yusaf, Talal , Soufi, Masoud , Hoseini, Seyed
- Date: 2019
- Type: Text , Journal article
- Relation: Energies Vol. 12, no. 14 (2019), p. 1-14
- Full Text:
- Reviewed:
- Description: In recent years, due to the favorable climate conditions of Iran, the cultivation of rapeseed has increased significantly. The aim of this study was to investigate the possibility of biodiesel production from one genotype of rapeseed (TERI (OE) R-983). An ultrasonic approach was used in order to intensify the reaction. Response surface methodology (RSM) was applied to identify the optimum conditions of the process. The results of this research showed that the conversion of biodiesel was found to be 87.175% under the optimized conditions of a 4.63:1 molar ratio (methanol to oil), 56.50% amplitude, and 0.4 s pulses for a reaction time of 5.22 min. Increasing the operating conditions, such as the molar ratio from 4:1 to 5.5:1, amplitude from 50% to 72.5%, reaction time from 3 min to 7 min, and pulse from 0.4 s to 1 s, increased the FAME (fatty acid methyl esters) yield by approximately 4.5%, 2.3%, 1.2%, and 0.5%, respectively. The properties of the TERI (OE) R-983 methyl ester met the requirements of the biodiesel standard (ASTM D6751), indicating the potential of the produced biodiesel as an alternative fuel.
The influence of emulsified water fuel containing fresh water microalgae on diesel engine performance, combustion, vibration and emission
- Authors: Al-Lwayzy, Saddam , Yusaf, Talal , Saleh, Khalid , Yousif, Belal
- Date: 2019
- Type: Text , Journal article
- Relation: Energies Vol. 12, no. 13 (2019), p. 1-17
- Full Text:
- Reviewed:
- Description: Microalgae is considered as an excellent potential renewable source of fuel in many forms including powder or slurry. A high percentage of emulsified water in the fuel is reported to reduce diesel engines’ emissions such as NOx, but that will compromise the engine output power. Using microalgae powder as an additive to enhance the emulsified water fuel heating value is the main objective of this work. Diesel engine combustion, vibration, performance and emissions were evaluated for pure cottonseed biodiesel (CS-B100), emulsified water 20% (vol.) in cottonseed biodiesel (CSB-E20) and emulsified water 20% (vol.) containing Fresh Water Microalgae Chlorella Vulgaris (FWM-CV) in cottonseed biodiesel (CSB-ME20). The emulsified water fuels showed a reduction in in-cylinder pressure, vibration, brake power, torque, exhaust gas temperature, CO2 and NOx, while BSFC and O2 were higher than the pure biodiesel (CS-B100). CSB-ME20 produced higher power and torque than CSB-E20 due to the presence of microalgae in the fuel that increased the energy content of the fuel.
Artificial neural network modeling and sensitivity analysis of performance and emissions in a compression ignition engine using biodiesel fuel
- Authors: Jaliliantabar, Farzad , Ghobadian, Barat , Najafi, Gholamhassan , Yusaf, Talal
- Date: 2018
- Type: Text , Journal article
- Relation: Energies Vol. 11, no. 9 (2018), p. 1-24
- Full Text:
- Reviewed:
- Description: In the present research work, a neural network model has been developed to predict the exhaust emissions and performance of a compression ignition engine. The significance and novelty of the work, with respect to existing literature, is the application of sensitivity analysis and an artificial neural network (ANN) simultaneously in order to predict the engine parameters. The inputs of the model were engine load (0, 25, 50, 75 and 100%), engine speed (1700, 2100, 2500 and 2900 rpm) and the percent of biodiesel fuel derived from waste cooking oil in diesel fuel (B0, B5, B10, B15 and B20). The relationship between the input parameters and engine cylinder performance and emissions can be determined by the network. The global sensitivity analysis results show that all the investigated factors are effective on the created model and cannot be ignored. In addition, it is found that the most emissions decreased while using biodiesel fuel in the compression ignition engine.
Performance assessment of a solar dryer system using small parabolic dish and alumina/oil nanofluid : simulation and experimental study
- Authors: Arkian, Amir , Najafi, Gholamhassan , Gorjian, Shiva , Loni, Reyhaneh , Bellos, Evangelos , Yusaf, Talal
- Date: 2019
- Type: Text , Journal article
- Relation: Energies Vol. 12, no. 24 (Dec 2019), p. 22
- Full Text:
- Reviewed:
- Description: In this study, a small dish concentrator with a cylindrical cavity receiver was experimentally investigated as the heat source of a dryer. The system was examined for operation with pure thermal oil and Al2O3/oil nanofluid as the working fluids in the solar system. Moreover, the design, the development, and the evaluation of the dried mint plant are presented in this work. Also, the solar dryer system was simulated by the SolidWorks and ANSYS CFX software. On the other side, the color histogram of the wet and dried mint samples based on the RGB method was considered. The results revealed that the different temperatures of the solar working fluids at the inlet and outlet of the cavity receiver showed similar trend data compared to the variation of the solar radiation during the experimental test. Moreover, it is found that the cavity heat gain and thermal efficiency of the solar system was improved by using the nanofluid as the solar working fluid. Furthermore, the required time for mint drying had decreased by increasing the drying temperature and increasing air speed. The highest drying time was measured equal to 320 min for the condition of the air speed equal to 0.5 m/s and the drying temperature of 30 degrees C. A good agreement was observed between the calculated numerical results and measured experimental data. Finally, based on the color histogram of the wet and dried mint samples, it was concluded that intensity amount of the red color of the mint increased with the drying process compared to intensity amount of the red color of the wet mint sample.
Energy sector development : system dynamics analysis
- Authors: Laimon, Mohamd , Mai, Thanh , Goh, Steven , Yusaf, Talal
- Date: 2020
- Type: Text , Journal article
- Relation: Applied Sciences-Basel Vol. 10, no. 1 (Jan 2020), p. 19
- Full Text:
- Reviewed:
- Description: The development of a complex and dynamic system such as the energy sector requires a comprehensive understanding of its constituent components and their interactions, and thus requires approaches that can adapt to the dynamic complexity in systems. Previous efforts mainly used reductionist approaches, which examine the components of the system in isolation, neglecting their interdependent nature. Such approaches reduce our ability to understand the system and/or mitigate undesirable outcomes. We adopt a system dynamics approach to construct an integrated model for analysing the behaviour of the energy sector. Although the Australian energy sector is used as a case study, the model can be applied in other context elsewhere around the world The results indicate that the current trajectory of the Australian energy sector is unsustainable and growth is not being controlled. Limits to growth are fast approaching due to excessive fossil fuel extraction, high emissions and high energy dependency. With the current growth, Australia's global CO2 emissions footprint will increase to unprecedented levels reaching 12% by 2030 (9.5% for exports and 2.5% for domestic). Oil dependency will account for 43% and 47% of total consumption by 2030 and 2050. By 2032, coal will be the only fossil fuel resource available in Australia. Expansion of investment in coal and gas production is a large risk.
The impacts of water pricing and non-pricing policies on sustainable water resources management : A case of Ghorveh Plain at Kurdistan province, Iran
- Authors: Asaadi, Mohammad , Mortazavi, Seyed , Zamani, Omid , Najafi, Gholam , Yusaf, Talal , Hoseini, Seyed
- Date: 2019
- Type: Text , Journal article
- Relation: Energies Vol. 12, no. 14 (2019), p. 1-16
- Full Text:
- Reviewed:
- Description: As with other regions of Iran, due to excessive extraction of groundwater for intense agricultural activity, Ghorveh plain, a water-scarce irrigation district in the west of Iran, has faced a serious water crisis during the last decade. The present study investigates the impacts of two scenario policies, namely, non-price policy (as a supply-oriented policy) and water pricing policies (as a demand-oriented policy) on agricultural sector of Ghorveh Plain, using positive mathematical programming (PMP). The model was calibrated by using farm-level data for the crop years in 2016-2017. Our findings indicate that applying water supply constraint policy will change the land use and cropping pattern to the crops with higher water productivity. The increase of water resource constraints can lead to the increase of water economic return which indicates a rising value of water resources shortage, warning the producers of the agriculture sector to allocate water to the crops with higher economic value under the water resources shortage conditions. In addition, the findings underline that in a situation where the price of irrigation water is low due to the low elasticity of water demand in the agriculture sector, formulating the economic instruments such as rising water prices does not solely suffice to achieve sustainable water resource management. However, mixed scenarios emphasized that the water distribution policies should be aligned with the increases in water cost.