Water uptake and its impact on the texture of lentils (Lens culinaris)
- Authors: Joshi, Matina , Adhikari, Benu , Panozzo, Joe , Aldred, Peter
- Date: 2010
- Type: Text , Journal article
- Relation: Journal of Food Engineering Vol. 100, no. 1 (2010), p. 61-69
- Full Text: false
- Reviewed:
- Description: Water uptake behavior of three cultivars of lentils (Boomer, French-green and Nugget) was studied at three different hydration temperature regimes (room temperature, 50 °C and 85 °C). Boomer had the highest amount of water uptake capacity (74.60 g water/100 g of seeds) at room temperature (20 °C) which can be linked with its pore properties. French-green lentils imbibed the largest amount of water at elevated soaking temperatures (50 °C and 85 °C) and can be attributed to its higher seed surface area to volume ratio, high protein content and relatively thinner seed coat. Water uptake at elevated temperatures (50 °C and 85 °C) were predicted by a two parameter Mitscherlich model (R2 > 0.99,
- Description: 2003008231
Physicochemical and functional properties of lentil protein isolates prepared by different drying methods
- Authors: Joshi, Matina , Adhikari, Benu , Aldred, Peter , Panozzo, Joe , Kasapis, Stefan
- Date: 2011
- Type: Text , Journal article
- Relation: Food Chemistry Vol. 129, no. 4 (2011), p. 1513-1522
- Full Text: false
- Reviewed:
- Description: Lentil protein isolate (LPI) extract was converted into powder by freeze drying, spray drying and vacuum drying. Differences in particle size distribution, protein subunit composition and colour and surface morphology were observed amongst the three drying methods. Spray and freeze-dried LPI powders exhibited higher solubility (81% and 78%, respectively) compared to vacuum dried powders (50%). The spray dried powders showed a low water absorption capacity (0.43 ± 0.02 g/g) compared to freeze (0.48 ± 0.02 g/g) and vacuum-dried (0.47 ± 0.01 g/g) LPI powders. Spray and freeze-dried powders displayed better gelation ability and higher gel strength, compared to vacuum-dried powder. Both spray and freeze-dried gels showed typical viscoelastic gel characteristics, with G′ dominating over G″ and very low loss tangent. The holding time required for gelation of vacuum dried powder at 90 °C was significantly longer, compared to spray and freeze dried powders. Hence, drying methods used for preparation of lentil protein isolate powders can affect physicochemical and associated functional properties. © 2011 Elsevier Ltd. All rights reserved.
Physicochemical and functional characteristics of lentil starch
- Authors: Joshi, Matina , Aldred, Peter , McKnight, Stafford , Panozzo, Joe , Kasapis, Stefan , Adhikari, Raju , Adhikari, Benu
- Date: 2013
- Type: Text , Journal article
- Relation: Carbohydrate Polymers Vol. 92, no. 2 (2013), p. 1484-1496
- Full Text: false
- Reviewed:
- Description: The physicochemical properties of lentil starch were measured and linked up with its functional properties and compared with those of corn and potato starches. The amylose content of lentil starch was the highest among these starches. The crystallinity and gelatinization enthalpy of lentil starch were the lowest among these starches. The high amylose: amylopectin ratio in lentil starch resulted into low crystallinity and gelatinization enthalpy. Gelatinization and pasting temperatures of lentil starch were in between those of corn and potato starches. Lentil starch gels showed the highest storage modulus, gel strength and pasting viscosity than corn and potato starch gels. Peleg's model was able to predict the stress relaxation data of these starches well (R2 > 0.98). The elastic modulus of lentil starch gel was less frequency dependent and higher in magnitude at high temperature (60 °C) than at lower temperature (10 °C). Lentil starch is suitable where higher gel strengthened pasting viscosity are desired. © 2012 Elsevier Ltd.
- Description: 2003011035