Effect of pyrolysis conditions on bone char characterization and its ability for arsenic and fluoride removal
- Authors: Alkurdi, Susan , Al-Juboori, Raed , Bundschuh, Jochen , Bowtell, Les , McKnight, Stafford
- Date: 2020
- Type: Text , Journal article
- Relation: Environmental Pollution Vol. 262, no. (2020), p.
- Full Text: false
- Reviewed:
- Description: This study examined arsenite [As(III)], arsenate [As(V)] and fluoride (F−) removal potential of bone char produced from sheep (Ovis aries) bone waste. Pyrolysis conditions tested were in the 500 °C–900 °C range, for a holding time of 1 or 2 h, with or without N2 gas purging. Previous bone char studies mainly focused on either low or high temperature range with limited information provided on As(III) removal. This study aims to address these gaps and provide insights into the effect of pyrolysis conditions on bone char sorption capacity. A range of advanced chemical analyses were employed to track the change in bone char properties. As pyrolysis temperature and holding time increased, the resulting pH, surface charge, surface roughness, crystallinity, pore size and CEC all increased, accompanied by a decrease in the acidic functional groups and surface area. Pyrolysis temperature was a key parameter, showing improvement in the removal of both As(III) and As(V) as pyrolysis temperature was increased, while As(V) removal was higher than As(III) removal overall. F− removal displayed an inverse relationship with increasing pyrolysis temperature. Bone char prepared at 500 °C released significantly more dissolved organic carbon (DOC) then those prepared at a higher temperature. The bone protein is believed to be a major factor. The predominant removal mechanisms for As were surface complexation, precipitation and interaction with nitrogenous functional groups. Whereas F− removal was mainly influenced by interaction with oxygen functional groups and electrostatic interaction. This study recommends that the bone char pyrolysis temperature used for As and F− removal are 900 °C and 650 °C, respectively. © 2020 Elsevier Ltd
- Description: This research was performed as a part of PhD research which was supported in part by the Iraqi Government and the Australian Research Training Program.
Bone char as a green sorbent for removing health threatening fluoride from drinking water
- Authors: Alkurdi, Susan , Al-Juboori, Raed , Bundschuh, Jochen , Hamawand, Ihsan
- Date: 2019
- Type: Text , Journal article , Review
- Relation: Environment International Vol. 127, no. (2019), p. 704-719
- Full Text:
- Reviewed:
- Description: Millions of people around the world suffer from or prone to health problems caused by high concentration of fluoride in drinking water sources. One of the environmentally friendly and cost-effective ways for removing fluoride is the use of bone char. In this review, the structural properties and binding affinity of fluoride ions from different water sources was critically discussed. The effect of experimental conditions on enhancing the adsorption capacity of fluoride ions using bone char samples was addressed. It appears that surface properties, and conditions of the bone char production such as temperature and residence time play an important role in designing the optimal fluoride removal process. The optimum temperature for fluoride removal seems to be in the range of 500–700 °C and a residence time of 2 h. Applying various equilibrium adsorption isotherms for understanding fluoride adsorption mechanism was presented. The effect of bone char modification with different elements were discussed and recommendations for a further increase in the removal efficiency was proposed. Cost of bone char production and large-scale treatment systems were also discussed based on information available from scientific and commercial sources. Challenges with existing domestic defluoridation designs were highlighted and suggestions for new conceptual designs were provided.
Macadamia nutshell biochar for nitrate removal : Effect of biochar preparation and process parameters
- Authors: Bakly, Salam , Al-Juboori, Raed , Bowtell, Les
- Date: 2019
- Type: Text , Journal article
- Relation: C-Journal of Carbon Research Vol. 5, no. 3 (2019), p. 1-20
- Full Text:
- Reviewed:
- Description: Agricultural runoff is a major cause of degradation to freshwater sources. Nitrate is of particular interest, due to the abundant use of nitrogen-based fertilizers in agricultural practices globally. This study investigated the nitrate removal of biochar produced from an agricultural waste product, macadamia nutshell (MBC). Kinetic experiments and structural analyses showed that MBC pyrolsed at 900 degrees C exhibited inferior NO3- removal compared to that pyrolsed at 1000 degrees C, which was subsequently used in the column experiments. Concentrations of 5, 10 and 15 mg/L, with flowrates of 2, 5 and 10 mL/min, were examined over a 360 min treatment time. Detailed statistical analyses were applied using 2(3) factorial design. Nitrate removal was significantly affected by flowrate, concentration and their interactions. The highest nitrate removal capacity of 0.11 mg/g MBC was achieved at a NO3- concentration of 15 mg/L and flowrate of 2 mL/min. The more crystalline structure and rough texture of MBC prepared at 1000 degrees C resulted in higher NO3- removal compared to MBC prepared at 900 degrees C. The operating parameters with the highest NO3- removal were used to study the removal capacity of the column. Breakthrough and exhaustion times of the column were 25 and 330 min respectively. Approximately 92% of the column bed was saturated after exhaustion.
Pulsed ultrasound as an energy saving mode for ultrasound treatment of surface water with terrestrial aquatic carbon
- Authors: Al-Juboori, Raed , Yusaf, Talal , Bowtell, Leslie
- Date: 2018
- Type: Text , Journal article
- Relation: Desalination and Water Treatment Vol. 135, no. (2018), p. 167-176
- Full Text: false
- Reviewed:
- Description: The use of ultrasound technology in water treatment has gained great popularity in recent years owing to its benign environmental effects. The evaluation of this technology for water treatment purposes has mostly been conducted using synthetic water samples. This study however investigated the use of ultrasound for treating natural water with organic carbon predominantly derived from terrestrial sources. Ultrasound treatments were applied in continuous and pulsed modes with a range of On: Off ratios (R) and power intensity of 21.5 W/cm2 for 4 min. Physio-chemical and spectroscopic measurements were applied to determine the effect of ultrasound treatments on the concentration and structure of dissolved organic carbon (DOC) in the treated water. Post-hoc statistical analysis at a significance level of 0.05 showed that the performance of pulsed ultrasound treatments at least at one of pulse settings was better than that of continuous treatment. Overall, it was found that ultrasound treatments decreased DOC in the treated water and altered its nature to become more reactive towards oxidation and electrochemical reactions. Energy and cost analysis for DOC removal have also been conducted and results showed that applying the appropriate pulse settings can reduce the cost of the treatment by more than a half.
Biochar versus bone char for a sustainable inorganic arsenic mitigation in water : What needs to be done in future research?
- Authors: Alkurdi, Susan , Herath, Indika , Bundschuh, Jochen , Al-Juboori, Raed , Vithanage, Meththika , Mohan, Dinesh
- Date: 2019
- Type: Text , Journal article , Review
- Relation: Environment International Vol. 127, no. (2019), p. 52-69
- Full Text:
- Reviewed:
- Description: Arsenic (As) is an emerging contaminant on a global scale posing threat to environmental and human health. The relatively brief history of the applications of biochar and bone char has mapped the endeavors to remove As from water to a considerable extent. This critical review attempts to provide a comprehensive overview for the first time on the potential of bio- and bone-char in the immobilization of inorganic As in water. It seeks to offer a rational assessment of what is existing and what needs to be done in future research as an implication for As toxicity of human health risks through acute and chronic exposure to As contaminated water. Bio- and bone-char are recognized as promising alternatives to activated carbon due to their lower production and activation cost. The surface modification via chemical methods has been adopted to improve the adsorption capacity for anionic As species. Surface complexation, ion exchange, precipitation and electrostatic interactions are the main mechanisms involved in the adsorption of As onto the char surface. However, arsenic-bio-bone char interactions along with their chemical bonding for the removal of As in aqueous solution is still a subject of debate. Hence, the proposed mechanisms need to be scrutinized further using advanced analytical techniques such as synchrotron-based X-ray. Moving this technology from laboratory phase to field scale applications is an urgent necessity in order to establish a sustainable As mitigation in drinking water on a global scale.