Description:
Spray drying behavior of orange juice concentrate with various levels of maltodextrin (DE 6) was studied. Five combinations of orange juice concentrate and maltodextrin (25:75, 30:70, 35:65, 40:60, and 50:50) were spray dried at 160 and 65 degrees C inlet and outlet temperatures, respectively. The product recovered with 50% maltodextrin concentration was sticky and only 20% powder was recovered. The recovery of orange juice powder increased as the amount of maltodextrin in powders increased. The particle size and bulk density remained almost the same in all except in 50% maltodextrin powder which was slightly larger and more dense. The moisture content of spray dried powders was high and desiccated before measuring glass transition temperature. The anhydrous spray dried powders showed increased T-g values with increasing maltodextrin concentration, from 66 degrees C in 50% maltodextrin to 97 degrees C in 75% maltodextrin containing powders. The glass rubber transition ( Tg-r) values of all the products measured using novel Thermal Mechanical Compression Test (TMCT) were higher than T-g values measured by DSC; the difference in values increased with increase in maltodextrin concentration.
Description:
Drying kinetics of low molecular weight sugars such as fructose, glucose, sucrose and organic acid such as citric acid and high molecular weight carbohydrate such as maltodextrin (DE 6) were determined experimentally using single drop drying experiments as well as predicted numerically by solving the mass and heat transfer equations. The predicted moisture and temperature histories agreed with the experimental ones within 6% average relative (absolute) error and average difference of +/- 1degreesC, respectively. The stickiness histories of these drops were determined experimentally and predicted numerically based on the glass transition temperature (T-g) of surface layer. The model predicted the experimental observations with good accuracy. A nonsticky regime for these materials during spray drying is proposed by simulating a drop, initially 120 mum in diameter, in a spray drying environment.